How To Draw A Man's Mouth

Download Article

Download Article

Like the eyes, the mouth can convey a lot of emotion, like happiness, sadness, excitement, and displeasure. Cartoon mouths can be tricky since everyone's rima oris is unlike, the right shapes to apply depend on the facial expression, and the shading tin modify based on the lighting. Fortunately, one time you lot larn how to depict a basic mouth, either closed or open up with teeth showing, yous'll be able to make adjustments depending on who y'all're drawing or what expression you want to convey.

1. 1

   Draw the line where both lips meet. This is the line where the bottom of the upper lip meets the top of the lower lip. The shape of this line is a little different on everyone, and information technology depends on what facial expression is being fabricated. More often than not, for a resting facial expression, this line has a slight upward bend on each side and a dip in the centre. Brand the dip about the aforementioned length as the upward curving lines on the ends.^[i]

   • Make the length of this line every bit wide as you lot desire the lips to exist.

2. 

   2

   Outline the top of the upper lip. Start at the left cease of the first line y'all drew, and so draw a line at an upwards angle, most ten-20°, to the right. Terminate when yous're above a petty less than the halfway signal on the first line y'all drew. Repeat on the correct end of the outset line you drew, this time drawing the angled line to the left. Finally, describe a shallow "U" shape between the ends of the angled lines. This will be the dip in the top of the upper lip.^[ii]

   Tip: Everyone'southward lips are different. This is a proficient place to start when yous're learning, simply you can e'er accommodate the upper lip as needed. The dip could exist wider or narrower, and the angled lines could bend upward or downwards. If you're drawing from a reference photo or model, use this as a guide, but attempt to capture the unique shape of their upper lip.

   Advertisement

3. 

   3

   Sketch the bottom of the lower lip. Showtime at i stop of the line where both lips run across. Then, draw a shallow "U" shaped line that stops at the other end of the line you started at. By and large, the lower lip is bigger than the upper lip (about 1 ½ times bigger). You tin make the lower lip even bigger, or have it be the same size as the upper lip.^[3]

   • To brand the lesser lip bigger, brand the "U" shaped line deeper. To make it smaller, make the "U" shaped line shallower.

4. 

   iv

   Add together in the vertical creases on the lips. If you look at someone's lips, you lot'll discover they're non perfectly shine. Lips have fine, vertical creases in them, which get more than pronounced as people age. These lines will be more noticeable in the lower lip, and then start there. Draw a series of effectually 10 lines that span beyond the lower lip. Repeat on the top lip, but depict fewer lines and make them shorter since they're usually less noticeable there.^[iv]

   • Vary the length of each line, and curve them slightly so the lines on the left one-half of the lips bend out to the left and the lines on the right one-half bend out to the right. Brand the lines near the heart of the lips relatively straight.

5. 

   v

   Shade in the lips to add dimension. The right way to shade the lips will depend on the lighting. If the lighting is above the face up, the shadows would fall at the bottom of each lip, so shade those areas the darkest. If the light is coming from the side of the confront, one half of the lips would exist darker (the half that'south contrary the lighting) than the other half. For straight-on lighting, there wouldn't be very many shadows. In that example, the darkest part of the lips would exist where the upper and lower lips run across.^[5]

   • Generally, the brightest areas will be the portions of the lips that stick out the most, like the middle of the lower lip and the top of the upper lip. Leave these areas white.
   • Shading volition add highlights and shadows to the lips, making them look more realistic.

   Advertisement

1. 

   one

   Draw an outline of the mouth. Start past drawing a horizontal line with a shallow up curve. Make this line as long every bit yous want the width of the oral fissure to be. This will be the bottom of the upper lip. Next, starting at one end of that line, draw a "U" shaped line that ends at the opposite terminate you started at. Make the "U" shaped line deep enough that you'll exist able to draw the teeth inside the rima oris. Make the distance between the everyman indicate on the "U" shaped line and the center of the curved horizontal line about ⅓ the length of the curved horizontal line.^[half-dozen]

   • At this signal, the mouth will have a assistant-like shape.

2. 

   2

   Sketch the top of the upper lip. Start at one finish of the curved horizontal line, and draw a shallow downwards-curving line that ends slightly above the halfway point on the curved horizontal line. And so, echo on the other side so the 2 downward-curving lines meet in the heart. Make the distance between that point and the halfway signal on the curved horizontal line most ⅓ the pinnacle of the mouth.^[7]

3. 

   3

   Outline the bottom of the lower lip. First at one stop of the curved horizontal line, and draw a "U" shaped line that ends on the opposite end. Exit a gap between this line and the start "U" shaped line you lot drew for the mouth. Make the gap progressively bigger the further abroad yous get from the starting indicate. When you lot're halfway to the other side, make the gap progressively smaller until you attain the other finish.^[8]

   • Brand the altitude between the lowest point on this line and the lowest point on the starting time "U" shaped line you drew about ½ the height of the mouth.

4. 

   4

   Draw partial rectangles across the length of the rima oris for the teeth. Start by drawing a partial rectangle in ane corner of the mouth. Don't draw the top of the rectangle since that's where the gums will go. Round out the bottom two corners of the rectangle, and angle the bottom edge so it's parallel with the height of the lower lip. Describe some other partial rectangle straight side by side to information technology, merely brand this i slightly taller. Repeat this process until you're done drawing the showtime front tooth. Now, practise the same thing on the other half of the mouth.^[9]

   • Draw the aforementioned number of teeth on each one-half, about v-half dozen.

5. 

   5

   Draw an arc above each tooth for the gums. First with the tooth at one end of the mouth, and draw a shallow arc over it. Take the summit of the arc line up with the lesser of the upper lip. Repeat for the rest of the teeth.^[10]

6. 

   6

   Shade in the gums and mouth. Shading will give your drawing dimension and make it expect more existent. Apply a pencil to shade in the inner portion of the rima oris, or the blank infinite under the teeth and in a higher place the lower lip, as night every bit you can. And so, fill in the gums a few shades lighter than that.^[11]

   Tip: Use the edge of your pencil tip to shade since it volition be easier to blend.

7. seven

   Add creases to the lips. To add creases the lips, which will make them wait more realistic, draw a series of curved vertical lines beyond the length of each lip. Vary the lengths of the lines, and have some start at the top of each lip and some start at the lesser. Brand the lines on the left half of the lips curve out to the left, and make the lines on the right half of the lips curve out to the correct.^[12]

   • Make about 10 creases on each lip.

8. 

   8

   Shade in the lips to finish your drawing. Lite casts shadows and highlights on the lips, and you tin capture these different shadows and highlights using shading. Shade in the ends of the lips at the corners of the mouth, the bottom of the superlative lip, and the meridian and bottom of the lower lip. Make this shade darker than the gums but lighter than the inner oral fissure. Leave the top of the upper lip and the middle of the lower lip white or just slightly shaded since those areas will have the most highlights.^[13]

   Advertisement

Add New Question

• Question

  Is in that location a way to make the drawing procedure easier?

  

  Atrooja Khan

  Community Answer

  If you proceed your hand loose, yous should get accurate results. After all, a sketch is a loose handed drawing. if you grip your utensil tightly, it won't turn out as well good -- if yous mess up, you won't be able to erase well and you lot may not like it.

• Question

  If I added more than lines (to create volume), would information technology look more realistic?

  

  It might, but it really depends on how many lines you already take. Having manner as well many won't expect realistic either.

• Question

  Wouldn't using a reference prototype and but copying it over make the procedure any easier?

  

  Yes, this volition make the process easier; almost professional artists use reference images ofttimes. Withal, it may still accept practice to become it perfect, as using references is still a skill to learn; don't be surprised if it isn't perfect the first time.

• Question

  How tin can I make a realistic center with a pencil?

  

  Shading is the cardinal to make anything look more realistic. Also, don't forget that the irises aren't just 1 solid color, in that location are designs in them.

• Question

  How do I draw the open smiling mouth easier?

  

  If you practice one way for so long, information technology will get easier, and later that, you tin even endeavor other styles.

• Question

  What practice you phone call the middle of the lip?

  

  The dip your lip makes at the superlative in the eye is chosen the Cupid's bow.

• Question

  How do I ready drawing the teeth as well large?

  

  That's easy to gear up with pencil drawings. There are many dissimilar sized erasers on the market, some are fifty-fifty moldable to suit your needs! You can ever look at your local arts shop for some good erasers. If y'all don't want to do that, or don't take time for shopping, simply gently using a regular eraser will practise fine. There are also some erasable pens, but I would not recommend them for cartoon purposes because they are very messy when you try to erase them. So just keep adjusting the teeth until you get a size yous are happy with!

• Question

  Is in that location an easier and more than "cartoonish" manner of drawing mouths?

  

  Attempt drawing a cartoonish mouth like y'all would draw bubble letters.

• Question

  How do I correctly draw volume lines for a oral fissure?

  

  Slight blended curves work the best.

• Question

  How do I draw a slightly parted mouth?

  

  Draw the top lip, and then add together just the bottom of the 2 forepart teeth (and maybe a few other teeth, depending on how much you lot want the mouth to be open up), and then you can draw the bottom lip.

See more answers

Ask a Question

200 characters left

Include your electronic mail accost to go a message when this question is answered.

Submit

Advertizing

Video

Thanks for submitting a tip for review!

About This Article

Commodity Summary 10

To depict a mouth, start past cartoon a horizontal line with the ends tilted upwards. Next, sketch an arch above and below the horizontal line, making sure the arches stretch the length of the horizontal line. Make the height arch slightly smaller than the bottom arch and dip it at the top. Then, add short, vertical arched lines coming out of the horizontal line to add detail. Finally, color in the mouth with a cerise or pink color and add a petty bit of shading to make information technology wait natural. To acquire how to draw a smiling mouth, proceed reading!

Did this summary help y'all?

Thanks to all authors for creating a folio that has been read 740,281 times.

Did this article help you?

Source: https://www.wikihow.com/Draw-Mouths

Posted by: gordonopoetinat1997.blogspot.com

Share this post